[DogParkList] MacLoggerDX Icom Transceive Commands
Don Agro
dagro@dogparksoftware.com
Sun, 15 Feb 2004 07:47:33 -0500
The most recent release of MacLoggerDX (v3.9.1) supports Icom
Transceive commands.
These commands tell anyone listening on the CI-V bus that you have
changed the frequency or mode of the rig manually via the radio's front
panel.
If you experience any sluggishness of the VFO response while CI-V
Transceive is enabled try turning it off in the Icom set-up menus.
It is not necessary for Transceive mode to be enabled for MacLoggerDX
to work, but it is required by some band sensing antenna switchers etc.
73 Don Agro VE3VRW
D o g P a r k S o f t w a r e L t d .
email: dagro@dogparksoftware.com
www: http://www.dogparksoftware.com
iChat AV:dogpark@mac.com