[reportlab-users] rotate page

[Robin Becker]

giulia cherubini wrote:

> Well,

> I’m trying to rotate a table-grid, but…result is non as I exactly want to be…

> Now I can see a bit of table, but…it’s not enough!!!

> I have a little trouble understanding:

> --- wich kind of pagesize I have to set

> ---which value put onto canvas.translate

> ---values of inch

> I only rotate first page.

> The parameter rotate(90) is ok, I can see the end of table in the right position but…only the end!!!

> Thanx for your help, sorry if I’m very newbie!!!

> giulia

........

first off at the end of each page the graphic state is reset by adobe. That 
means you'll have to do the rotation in each page.

It's a bit odd to use negative page width so I don't know what's happening here. 
Try changing the two inch,inch translations one at a time, by a small amount to 
determine which direction the drawn table gets moved. That should allow you to 
figure out what the correct adjustment should be for your set up.

I cannot run your example as I don't have data/psychopg2.
-- 
Robin Becker