[meteorite-list] Cutting An Iron
almitt2 at localnet.com
almitt2 at localnet.com
Sat Jul 2 14:10:06 EDT 2016
Hi John,
Using a CBN Blade sold by the company you referred to is a bad idea
in my experience. In the past I used their blades and they were great
early on. Don't know what happened but the quality of the blades went
down and I coudn't even cut a half inch before the material on the
blade wore off. I could feel on the blade where it was smooth and other
areas maybe still a little cutting material left.
I commented to the company owners before they sold the business and
they were concerned as I showed them the blades and mentioned how long
the blades lasted. However the problem was never solved and I stopped
wasting my $$ on the blades.
I don't recommend that someone who hasn't cut meteorites before cut
off a sample. Picking the right spot so as not to detract from the mass
is important. No doubt you will get a lot of people offering to cut for
you, some good some not so good. Why not take it to the meteorite lab
in Portland to have a sample cut. I would bet they would allow you to
be there during the cutting.
I'd make sure they know what they are doing as I have seen cutting
jobs messed up by some of the best known institutions. One place lost
over a kilo of material from their lack of knowledge of the material.
Good luck!
--AL Mitterling
Mitterling Meteorites
Quoting John Pierce via Meteorite-list <meteorite-list at meteoritecentral.com>:
> Hello All,
>
>
>
> This is my first post here. I joined recently because I found a lovely
> nickel-iron meteorite, and that has spurred my further interest in this
> subject. My meteorite has been confirmed as the real thing by staff of the
> Meteorite Lab at Portland State University, who would like to perform
> classification. It is 11.2 kg, and according to PSU staff, it will be only
> the seventh classified meteorite ever found in the state of Oregon.
>
>
>
> I?ve enjoyed reading these archives, but I haven?t yet been able to find
> answer to my question.
>
>
>
> I?m posting here to ask if anyone has any experience cutting an iron
> meteorite with the CBN blade that is sold by Johnson Brothers Lapidary. They
> advertise it as just the thing for cutting irons. I?m interested to know
> anything about blade life, rim speed, feed rate, and using plain water as a
> coolant/lubricant. For cutting the analysis sample, I have machining
> experience and very suitable tools, except for the blade, which I would
> like to be a circular blade.
>
>
>
> I welcome replies here on the forum, or by private email.
>
>
>
> Kind regards,
>
> John
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://pairlist3.pair.net/mailman/private/meteorite-list/attachments/20160702/9bb5f7ed/attachment.html>
More information about the Meteorite-list
mailing list