[meteorite-list] wire saw cost
Gary Fujihara
fujmon at mac.com
Thu Mar 10 18:32:16 EST 2011
Aloha Andre,
Depending on the cost of the material, it may or may not be more cost effective to use a wire saw. A wire saw is better for planetaries or other expensive or rare meteorites, where cost of material is high, and so minimizing cut loss is imperative. If the material is cheap, then the expense of using a wire saw is not justified for minimizing cut loss because you would spend more money on cutting it than you would saving on reduced cut loss.
You have to balance the cost of cutting with expected cut loss .
For example, a friend cut a cheap CV3 on a wire, and cost him big money to do so. He would have been better off taking the cut loss on a lap saw for a cheaper cutting expense.
gary
On Mar 10, 2011, at 12:59 PM, André Moutinho wrote:
> Hello,
>
> Does anyone can give me an idea of cutting cost using a wire saw to cut a 300g ordinary chondrite into 3mm slices?
>
> Thanks!
> Andre
> ______________________________________________
> Visit the Archives at http://www.meteoritecentral.com/mailing-list-archives.html
> Meteorite-list mailing list
> Meteorite-list at meteoritecentral.com
> http://six.pairlist.net/mailman/listinfo/meteorite-list
Gary Fujihara
Big Kahuna Meteorites (IMCA#1693)
105 Puhili Place, Hilo, Hawai'i 96720
http://bigkahuna-meteorites.com/
http://shop.ebay.com/fujmon/m.html
(808) 640-9161
More information about the Meteorite-list
mailing list