[meteorite-list] Working with Sikhote Aline
Pat Brown
radio_ranch at yahoo.com
Sun Dec 10 16:44:56 EST 2006
Hi M.Mackintosh and the list,
While I have never drilled a hole in a meteorite (the
alloy of iron, nickel etc should be no worse than low
grade stainless steel), I believe that a sharp cobalt
alloy drill bit available at Home Depot etc should do
a fine job of drilling a hole in your S A. I would
lube the bit with cutting oil (you could use any light
oil if you don't have cutting oil). It would be a good
idea to drill a bit at a time and add oil to the bit
each time. Start slowly to prevent the bit from
wandering.
As far as welding, I will defer to another listee.
With Best Regards,
Pat Brown
R&D Engineer
Agilent Technologies
--- "m.mackintosh" <m.mackintosh at bluewin.ch> wrote:
> Dear List,
>
> Could anyone tell me what one needs to:
>
> 1. Drill a small hole through a Sikhote Aline. ? I
> can only suppose it needs
> a special drill, but what ?
>
> 2. Weld onto a Sikhote Aline ? Here I guess it's a
> problem of temperature to
> create a good weld, and with what soldering material
> should it be welded ?
>
> Thank you very much for any response.
>
> Moray
>
>
> ______________________________________________
> Meteorite-list mailing list
> Meteorite-list at meteoritecentral.com
>
http://six.pairlist.net/mailman/listinfo/meteorite-list
>
____________________________________________________________________________________
Want to start your own business?
Learn how on Yahoo! Small Business.
http://smallbusiness.yahoo.com/r-index
More information about the Meteorite-list
mailing list