[DogParkList] DogParkList Digest, Vol 50, Issue 3

[Steve - VA3SPH]

Hi Mike,

Don't have my icom hooked up at the moment, but it is working to a  
Kenwood TS-2000.  I am using version v 4.3.4 of MacLoggerDX and .55 of  
CocoaModem.

I am assuming you have radio control using MacLoggerDX?  IE. you can  
change freq. and read freq. from your ProIIIusing Macloggerdx???  In  
MacLoggerDX if you press the Keyers button do you have "soft" only  
checked? What do you have checked?

In Cocoamodem you have to select "MacLoggerDX" in EACH of individual  
modes config (RTTY, WIdeband RTTY, DUAL RTTY, PSK etc...). You may  
need to set each of these again depending what version you updated  
from as there were quite a few changes to prefs in latest version.  I  
think you will find it still works once you go through each the prefs  
for each digital mode.

A little more information would help. Is everything else working but  
ptt?

73
Steve - VA3SPH


On 21-Aug-08, at 6:12 PM, dogparklist-request at dogparksoftware.com wrote:


> Subject: [DogParkList] Cocoamodem no longer communicates a CI-V TX/RX

> To: dogparklist at dogparksoftware.com

> Message-ID: <6AECC73D-3241-4A4D-9C3F-6D10D919E627 at comcast.net>

> Content-Type: text/plain; charset=US-ASCII; format=flowed; delsp=yes

>

> I've updated both MacLogger and Cocoamodem recently.  Since then

> Cocoamodem is no longer able to use a CI-V TX/RX command through

> MacLogger.   Currently I am not setup to use DTR or CTS keying.

>

> I have an Icom 756ProIII.   The MacLogger/Cocoamodem combination has

> been working well for over a year...  now no joy...

>

> Any ideas??

>

> thanks

> Mike

> ab2ts