[DogParkList] MLDX and microKeyer
David Ferrington, M0XDF
M0XDF at Alphadene.co.uk
Sun Mar 30 19:04:05 EDT 2008
Presumably you have changed the MLDX driver to be K3 instead of K2 -
check the DTR & RTS settings, the baud and delay etc, just in case
they changed somehow.
Other than that, I don't know what to suggest
73 de M0XDF, K3 #174, DigiKeyer
--
If a man will begin with certainties, he shall end in doubts; but if he
will be content to begin with doubts, he shall end in certainties.
-Francis Bacon, essayist, philosopher, and statesman (1561-1626)
On 30 Mar 2008, at 23:48, John Graf wrote:
>
> I am not 100% convinced that this question belongs here, as opposed
> to the microHam or K3 forums, but it is a good place to start.
>
> Until recently, I was using MLDX with my K2 and a microKeyer.
> Everything worked well, regardless of the mode.
>
> Now I have a K3. I did a "fork-lift" upgrade from the K2 to the K3,
> using all the same connectors, cable, and equipment.
>
> Almost everything works. However, I cannot get the system to enable
> PTT when using SSB. The relay clicks in the microKeyer when I hit
> the mic button, but there is no transmit light and of course,
> nothing going out. I tried every combination of configurations for
> the microKeyer in MLDX (AAA, BBB, etc.) but no change.
>
> Why I think that this may be a MLDX issue is that I can open a
> Windows session (using Parallels) and without changing any cabling
> or any settings on the K3, it works fine. With N1MM for example, I
> get PTT and power out by just hitting the mic button.
>
> So, does anyone have any ideas? I would appreciate some help. In
> the meantime I can bypass the microKeyer and go directly to the
> front microphone connector, but what is the fun in that? :-)
More information about the DogParkList
mailing list